Fabric8r.com Forums
Graph-based modeler, Antimony - Printable Version

+- Fabric8r.com Forums (https://fabric8r.com/community)
+-- Forum: 3D Printing (https://fabric8r.com/community/forum-4.html)
+--- Forum: 3D Printing Software (https://fabric8r.com/community/forum-23.html)
+--- Thread: Graph-based modeler, Antimony (/thread-9.html)

Graph-based modeler, Antimony - MisterAcoustic - 2017-11-17

Hi All,

I just found this. It was apparently released a few years ago, but I had never seen it. It looks like a nice alternative similar to OpenSCAD.



It requires a little work - depending on your platform, you might have to build the software yourself:

I'm looking forward to checking it out a little more closely - but I'm on a variety of linux where I'll have to build it. So, I haven't done that yet.

Hope someone finds this useful.