Looking for Setup Instructions - OneUp/TwoUp

[CyberMars]

I've decided I should print a better printer, but in order to do so I need to get my OneUp printer that I've had partially assembled in storage for a long time put together. However I can't find the assembly/setup instructions anywhere. Anyone by chance have those in digital form they can send or physical form they can photograph and send? I'd appreciate it.

[MisterAcoustic]

Hi CyberMars,

Welcome to the forums!

I probably do have those instructions... somewhere. I will go poke around and see what I can find. The only thing that concerns me is that I did lose an important hard drive a while back that I haven't recovered yet. I hope that's not the only place I had it.

Working...

[MisterAcoustic]

Unfortunately, I've failed in my initial search. The document isn't on my main machine. But I'm not done yet...

I didn't get a chance today, but tomorrow I'll boot up an older machine that I used to run my TwoUp, and see if it's there. I'm pretty hopeful that it is, but I will let you know what I find.

[CyberMars]

Thanks for taking some time to look. I scoured the internet for a couple days and couldn't find anything.

[CyberMars]

I thought I should add, everything's actually assembled except for connecting the wires. And then of course I need any relevant software bits, which I think I've seen some custom software bits somewhere that should work I assume, though I of course haven't tried any. 

So if you are still unable to find the instructions, if you happen to still have yours put together or just know which wires go where...

[MisterAcoustic]

Hi CyberMars,

Sorry for another delay responding. Okay, I've booted two old computers, and I haven't found the document/s yet. It is confusing to me that I don't have them close at hand, since I made a point to download the latest from the last QU-BD site before it went belly up. Maybe the files got named something strange.

Anyway, the wiring is an easier question, however I have an original kickstarter model that started out as a OneUp and was upgraded to a TwoUp. This means that I likely don't have the same board as you do, and I believe they also made some of the power supply wiring easier in the later models.

I let it get late tonight, so tomorrow I will post a couple of pictures of my setup, just in case it helps. If you have a newer model, we may have to improvise .

[MisterAcoustic]

Wait!

I take it all back. I believe I have found them. I will add the files here shortly.

[MisterAcoustic]

Hi CyberMars,

Okay, these look like the real deal. There are a couple of versions, so I hope you can match them with what you need.

I hope these help. Let us know how it goes. Good luck!

[CyberMars]

That's wonderful! Everything's working great now. Well, haven't actually printed anything yet, but otherwise it's all going fine. Still a bit undecided on what printer to uh... print... but I've got a couple ideas. 

Thanks for the help!
(As a side note I'm now going to make sure these documents are added to The Internet Archive, so they're at least in a fixed location and searchable.)

[CyberMars]

Permanent link on The Internet Archive:

https://archive.org/details/OneUpV3Instructions

Contains all 3 PDF files, should be suitable for linking anywhere else on the net.