2018-06-29, 03:18 AM
Hello bean users . So i got my bean a few days ago . First thing i did was spend a day figuring it out . Looks like mine runs on a raspberry pi 3 . ramps 1.4 . So far my prints are limited to the SLAcer. I've bean only able to print out 25 um .025 mm . Anything over 2600 slices or so and it wont make a zip and crashes. Second thing i noticed is the thing sweats a lot . I constantly have to clean the inside of the cover. I've already replaced the Teflon on the vat due to me not calibrating it properly and had a few dozen prints stick to the bottom of the vat. I've also had trouble when i wanted to check my prints . I would pause and then resume . But that gave me lines on my prints . That all said can anyone suggest a better app? im so tempted to use marlin or Octoprint . I couldn't access the pi but i can sure take the card out and replace it . Ya they changed the login and pass.
Vat... been there bean that... be very careful with the darn thing when you handle it . its so delicate . I've already stripped one of the screws out. broke a piece off of it . .
Other than that it prints wonderfully . So silent . love it . Definitely gona fool with it . Most likely replace the chip on the ramps board. Octoprint with the pi's built in wifi etc . add a camera etc.
Vat... been there bean that... be very careful with the darn thing when you handle it . its so delicate . I've already stripped one of the screws out. broke a piece off of it . .
Other than that it prints wonderfully . So silent . love it . Definitely gona fool with it . Most likely replace the chip on the ramps board. Octoprint with the pi's built in wifi etc . add a camera etc.