Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
An introduction
#5
flex shaft . never thought of that . i have seen videos on youtube . i have done a search for drill bits but havent found a place that is affordable would you have any suggestions? . what kinds of compounds are best? i just use the brown one that comes with my dremel . ive caste my own plastic model car motors . its in pewter. course my problem was polishing off details . the metal is so soft . i want it to look chrome. any ideas?
Reply


Messages In This Thread
An introduction - by ScottHepner - 2018-01-12, 07:59 PM
RE: An introduction - by MisterAcoustic - 2018-01-13, 12:24 PM
RE: An introduction - by evilpolygon - 2018-07-21, 05:40 AM
RE: An introduction - by ScottHepner - 2018-07-23, 09:09 PM
RE: An introduction - by evilpolygon - 2018-07-25, 01:56 PM
RE: An introduction - by ScottHepner - 2018-08-17, 04:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)