2018-09-22, 06:09 PM
update!
i was still having a over/under extrusion issue where i would have to manually tune the flowrates. well after tuning and setting microstepping on all 3 of my axis i realized that i had a 4th axis and my extrusion was at 250mm when it called for 100mm. after resolving that everything works as it should!
also installed a bowden setup and got almost all the weight off the x gantry. this has helped the x gantry skew quite a bit.
Working on a new printer build right now gonna be 400x200x200 h bot. little qubd is happily printing parts!
i was still having a over/under extrusion issue where i would have to manually tune the flowrates. well after tuning and setting microstepping on all 3 of my axis i realized that i had a 4th axis and my extrusion was at 250mm when it called for 100mm. after resolving that everything works as it should!
also installed a bowden setup and got almost all the weight off the x gantry. this has helped the x gantry skew quite a bit.
Working on a new printer build right now gonna be 400x200x200 h bot. little qubd is happily printing parts!