2017-12-08, 12:29 AM
(2017-12-07, 11:49 PM)ChuckP Wrote: Hello from a New Guy. I found a ThreeUp kit clearance priced (Marked at $255, rang at $165, and it was my birthday.) I've got the thing assembled, it powers up with no smoke leaks, and all the axes work except the extruder. Found a couple of bent pins in the connection between the AT-Mega and Ramps board, but correcting that still doesn't help.
For the sake of others, I'm hoping my experience is atypical.
Hi Chuck, and Welcome!
Hopefully, someone here will be able to help you out with the extruder issue. It would be nice if you could post about the specific issue/s in the Q3D/QU-BD area, so we don't hijack Joey's thread. If it's not clear from other posts on the site, I have to point out that this site is no longer associated with Q3D/QU-BD in any way - we're just hobbyists with some of their products trying to build a community to help each other out.
Unfortunately, you're experience isn't really atypical - the company has been poorly run, and may very well no longer exist (we have no idea).
So, start a thread in the other area, and give us some more details. We'll see what we can come up with.
Stan