Hello!
Welcome to the world of the QuBd. Your best bet, in my humble opinion, is to make the upgrade to the ramps 1.4/marlin combo.
The ramps community is dwindling with the up and coming allstars of the 32bit controller board world. But they are still cheap and a good intro to the Arduino community.
With my old qubd 2up, lord rest its soul, It made all the difference to have a decent following and plentiful marlin branches as well as all the accesories you could want for your printer.
I might still have an old version of the Marlin branch made for the qubd. its been a long while. what controller board are you using currently? i will look around and see what i can find. i think the one i had was for the red board.
The CR-10 is a great printer, i have a frankenTronXY X5S as my main workhorse. its only tronxy by name, its been upgraded with the Duet 2 wifi w/ 7in touch screen, bigger steppers, better belts, linear rails, e3d volcano and dual power supply combo.
im really a big fan of the CoreXY kinematics. The tronxyX5S can be had for about 300 and you get 330x330x400 build area. im building a delta right now too based on an old Geeeeeeeeeeeeeeeeeeeeetech 301. again its only that in name now.....
Cheers
Ben
Welcome to the world of the QuBd. Your best bet, in my humble opinion, is to make the upgrade to the ramps 1.4/marlin combo.
The ramps community is dwindling with the up and coming allstars of the 32bit controller board world. But they are still cheap and a good intro to the Arduino community.
With my old qubd 2up, lord rest its soul, It made all the difference to have a decent following and plentiful marlin branches as well as all the accesories you could want for your printer.
I might still have an old version of the Marlin branch made for the qubd. its been a long while. what controller board are you using currently? i will look around and see what i can find. i think the one i had was for the red board.
The CR-10 is a great printer, i have a frankenTronXY X5S as my main workhorse. its only tronxy by name, its been upgraded with the Duet 2 wifi w/ 7in touch screen, bigger steppers, better belts, linear rails, e3d volcano and dual power supply combo.
im really a big fan of the CoreXY kinematics. The tronxyX5S can be had for about 300 and you get 330x330x400 build area. im building a delta right now too based on an old Geeeeeeeeeeeeeeeeeeeeetech 301. again its only that in name now.....
Cheers
Ben