OneUp V2 Build Log.

[mr_intensity]

Extruder Plug Transplant

Progress, slow but sure...

NOTE: The following entry is about a week old.  Just when I start writing entries, again, we start having the hosting issues (grrrr...).  So, when I mention "Last week..." I actually mean two weeks ago, and when I say "...tomorrow's build night," I am actually talking about last week's build night, which I missed because I overslept and the radiator had not arrived until the next day, anyway...

Last week, as I waited for my car's engine to cool down, I cut the plug off the old extruder and soldered it on the new extruder.  I cut the plug far enough up the wire that I could just leave the label on there, so the wire is already labelled.  Some shrink wrap tubing finished off the job.

   

   

The rest of the night, I worked on my car.  All for naught, as it looks like I need a new radiator.  One is on order, and hopefully, it will be here by tomorrow's build night.

I really need to keep my car running.  It's sort of the priority at this point.