2019-05-13, 08:18 PM
Stand II
Stand in the place where you are...
As you remember from last year, I wanted to make my OneUp portable, and to that end, bolted it down on the stand where it currently sits. I used thin plywood, and have no place to add handles.
I will not be removing my OneUp from this stand. It all holds together rather nicely, and keeps the electronics board in place. However, I plan to bolt the entire kitandkaboodle down to a 2x6 plank of lumber, and put drawer handles on there.
A possible future expansion is the addition of an "overhead" handle, made of perforated angle iron. Even with the drawer handles on the base, I am sure at some point, some idiot will grab the thing from the top. So, I might as well have a (sturdy) handle up there.
I found a piece of 2x6 scrap in my chapter's scrap pile, and Jake cut it to size.
I will be painting, drilling, and screwing screws into it in the near future.
Stand in the place where you are...
As you remember from last year, I wanted to make my OneUp portable, and to that end, bolted it down on the stand where it currently sits. I used thin plywood, and have no place to add handles.
I will not be removing my OneUp from this stand. It all holds together rather nicely, and keeps the electronics board in place. However, I plan to bolt the entire kitandkaboodle down to a 2x6 plank of lumber, and put drawer handles on there.
A possible future expansion is the addition of an "overhead" handle, made of perforated angle iron. Even with the drawer handles on the base, I am sure at some point, some idiot will grab the thing from the top. So, I might as well have a (sturdy) handle up there.
I found a piece of 2x6 scrap in my chapter's scrap pile, and Jake cut it to size.
I will be painting, drilling, and screwing screws into it in the near future.
![[Image: avatar_23.png?dateline=1515658171]](https://fabric8r.com/community/uploads/avatars/avatar_23.png?dateline=1515658171){kind=avatar}