2019-05-20, 12:13 PM
Concerning the sway, give this one a look-see:
https://www.thingiverse.com/thing:962471
At least it works from the top. I am thinking the Z leadscrew can act as a third support when secured at the top. Maybe get some triangulation going in the handle to help brace things.
You ought to do a post on some of your mods. I would like to see your printed out Y-drive.
Also, it should not be hard to 3D-print an entire base. You would have to do it in sections (especially if you are using the OneUp to print it) though, and bolt together with M3/M4 hardware.
https://www.thingiverse.com/thing:962471
At least it works from the top. I am thinking the Z leadscrew can act as a third support when secured at the top. Maybe get some triangulation going in the handle to help brace things.
You ought to do a post on some of your mods. I would like to see your printed out Y-drive.
Also, it should not be hard to 3D-print an entire base. You would have to do it in sections (especially if you are using the OneUp to print it) though, and bolt together with M3/M4 hardware.
![[Image: avatar_23.png?dateline=1515658171]](https://fabric8r.com/community/uploads/avatars/avatar_23.png?dateline=1515658171){kind=avatar}