2017-12-08, 06:58 PM
Hi ChuckP,
Just wanted to check if you missed the reply from arocketguy to your other post. He said:
"2 things... Software won't let you run the extruder motor unless the hot end ... is hot. and 2nd, even if you have turned on the hot end - and it is truly hot - if the thermistor is not working then the software will still think it's cold and not let you turn on the extruder motor. "
We can hope that this is the issue so you don't have to replace your board. Kudos to arocketguy for the response!
Stan
Just wanted to check if you missed the reply from arocketguy to your other post. He said:
"2 things... Software won't let you run the extruder motor unless the hot end ... is hot. and 2nd, even if you have turned on the hot end - and it is truly hot - if the thermistor is not working then the software will still think it's cold and not let you turn on the extruder motor. "
We can hope that this is the issue so you don't have to replace your board. Kudos to arocketguy for the response!
Stan