New guy with ThreeUp startup issues

[ChuckP]

Hi ChuckP,

Just wanted to check if you missed the reply from arocketguy to your other post. He said:

"2 things... Software won't let you run the extruder motor unless the hot end ... is hot.  and 2nd, even if you have turned on the hot end - and it is truly hot - if the thermistor is not working then the software will still think it's cold and not let you turn on the extruder motor. "

We can hope that this is the issue so you don't have to replace your board. Kudos to arocketguy for the response!

Stan

Thanks for the heads-up. I hadn't checked the introduction thread yet. Let's hope this is what's needed.