The Bayliner dealer offered $500 trade on a 20' 90hp center console, plus galvanized trailer, off the $24K price
The 16 footer with an 80hp is undoubtedly a lot less, and the Outback should be able to tow it. Still not there, got a couple hundred worth of parts to install first. Who knows, the motor might even turn over with the starter after that crop of electrical gremlins get fixed.
Got the tilt/trim working OK, had to jump the limit switch since the override wire is broke where I can't get to it, got the lower end off (with a 2x4 and hammer, standard advice for stuck merc classic 50s), water pump rebuild starting tomorrow. Took a few hours off to have a tooth pulled and crown impressions made, should have used a door and string and used it for a boat down payment.
36 pounds of plywood and hardwood scheduled to arrive next Monday for the midget cnc router.
Kirk

Got the tilt/trim working OK, had to jump the limit switch since the override wire is broke where I can't get to it, got the lower end off (with a 2x4 and hammer, standard advice for stuck merc classic 50s), water pump rebuild starting tomorrow. Took a few hours off to have a tooth pulled and crown impressions made, should have used a door and string and used it for a boat down payment.
36 pounds of plywood and hardwood scheduled to arrive next Monday for the midget cnc router.
Kirk
------
KS Printrbot Plus, modified
Thingybot Delta
QU-BD One Up (parts, bad motor)
QU-BD RPM (unassembled parts, no spindle)
Maslow CNC V4.1 (4'x8' belt drive)
Zenbot Mini (6"x8", grbl_ESP32)
SainSmart 3018Pro, 4030V2, 4040 Pro
Ender 3 Pro, K1C
BobsCNC Revolution (FluidNC)
Eggbot
KS Printrbot Plus, modified
Thingybot Delta
QU-BD One Up (parts, bad motor)
QU-BD RPM (unassembled parts, no spindle)
Maslow CNC V4.1 (4'x8' belt drive)
Zenbot Mini (6"x8", grbl_ESP32)
SainSmart 3018Pro, 4030V2, 4040 Pro
Ender 3 Pro, K1C
BobsCNC Revolution (FluidNC)
Eggbot