2017-12-09, 12:32 AM
Hi ChuckP,
I think it might not be a hardware issue. I found this thread:
https://www.thingiverse.com/groups/prusa...topic:5575
Looks like there might be some g-code manipulation needed, depending on the cause. You could check first if the problem goes away if you power down and restart the printer - that would suggest the g-code changes might work.
Stan
I think it might not be a hardware issue. I found this thread:
https://www.thingiverse.com/groups/prusa...topic:5575
Looks like there might be some g-code manipulation needed, depending on the cause. You could check first if the problem goes away if you power down and restart the printer - that would suggest the g-code changes might work.
Stan