2017-12-09, 11:47 AM
I like the added G code just for safety's sake, but it didn't help here. In the end, I reversed the servo connection on the Ramps board, and now it at least feeds in the right direction.
I think I'm down to temperature issues now: What little plastic comes out doesn't stay put on the (heated) platen, and the extruder is feeding filament far faster than it comes out. I'm using the sample filament from the kit, which they politely neglected to tell me the composition of. I'm beginning to suspect its ABS, not PLA.
I think I'm down to temperature issues now: What little plastic comes out doesn't stay put on the (heated) platen, and the extruder is feeding filament far faster than it comes out. I'm using the sample filament from the kit, which they politely neglected to tell me the composition of. I'm beginning to suspect its ABS, not PLA.