2018-01-20, 11:22 PM
(This post was last modified: 2018-01-20, 11:26 PM by mr_intensity.
Edit Reason: Added title.
)
The Beginning (again)
Since the "new" forum is still kinda thin on content, I figured I would publish a build log here, as I attempt to build a Q3D OneUp V2 kit. I can document some of the mistakes/pitfalls I face, as sort of a pre-support role for others (i.e. You learn from my screw-ups).
For those not familiar with my odessey, I purchased a OneUp V2 kit a year ago, had a broken and a missing melemite part, tried to get support from the manufacturer, and got nowhere.
Anyway, I was all ready to attempt to build a Snappy 2.0, using the motors and electronics from this kit, when MrAcoustic really convinced me to attempt to build the OneUp.
Of course, it is a lot easier to get a friend with a 3D printer to print two small parts, than it is to get him to print an entire printer. :-D
So, the adventure begins...
Since the "new" forum is still kinda thin on content, I figured I would publish a build log here, as I attempt to build a Q3D OneUp V2 kit. I can document some of the mistakes/pitfalls I face, as sort of a pre-support role for others (i.e. You learn from my screw-ups).
For those not familiar with my odessey, I purchased a OneUp V2 kit a year ago, had a broken and a missing melemite part, tried to get support from the manufacturer, and got nowhere.
Anyway, I was all ready to attempt to build a Snappy 2.0, using the motors and electronics from this kit, when MrAcoustic really convinced me to attempt to build the OneUp.
Of course, it is a lot easier to get a friend with a 3D printer to print two small parts, than it is to get him to print an entire printer. :-D
So, the adventure begins...
![[Image: avatar_23.png?dateline=1515658171]](https://fabric8r.com/community/uploads/avatars/avatar_23.png?dateline=1515658171){kind=avatar}