Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Snappy V2.0: Land of confusion.
#18
As far as threads go, I stumbled across one that looked pretty good.  I started using it, and found out it was buried in my copy of the OpenSCAD manual, under the "Libraries" section:

http://dkprojects.net/openscad-threads

As for the OneUp, see attached.  My buddy printed the parts on Monday, and I pick them up tonight.

I may continue this thread (more like succeed this thread with a new one) over in the Q3D Printer Specific Discussion section, as I build my OneUp.


Attached Files Thumbnail(s)
   
[Image: avatar_23.png?dateline=1515658171]
Reply


Messages In This Thread
Snappy V2.0: Land of confusion. - by mr_intensity - 2018-01-08, 02:00 AM
RE: Snappy V2.0: Land of confusion. - by mr_intensity - 2018-01-19, 04:45 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)