Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
setting home/origin and more
#2
Hi xwarx7racer,

Sadly, I've never used an Octopi. A friend from work set one up for his Creality CR-10, but I don't know anything about it.

My main experience is with Repetier Host, and Cura. If one of those is running on the Octopi, I might be of more use, but I can't tell from your post.

In general, I don't think setting up your machine size in these softwares actually results in generated commands that don't exceed those bounds (though I may be wrong). I think the setup is more for visualization of model placement.

I have been a bit busy, but I will try to do a little research to see if I can put together enough knowledge to make some decent suggestions.

Stan
Reply


Messages In This Thread
setting home/origin and more - by xwarx7racer - 2018-08-29, 11:52 AM
RE: setting home/origin and more - by MisterAcoustic - 2018-08-30, 11:59 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)