Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
new to me oneup
#6
Hello!

Welcome to the world of the QuBd. Your best bet, in my humble opinion, is to make the upgrade to the ramps 1.4/marlin combo.
The ramps community is dwindling with the up and coming allstars of the 32bit controller board world. But they are still cheap and a good intro to the Arduino community.

With my old qubd 2up, lord rest its soul, It made all the difference to have a decent following and plentiful marlin branches as well as all the accesories you could want for your printer.

I might still have an old version of the Marlin branch made for the qubd. its been a long while. what controller board are you using currently? i will look around and see what i can find. i think the one i had was for the red board.

The CR-10 is a great printer, i have a frankenTronXY X5S as my main workhorse. its only tronxy by name, its been upgraded with the Duet 2 wifi w/ 7in touch screen, bigger steppers, better belts, linear rails, e3d volcano and dual power supply combo.
im really a big fan of the CoreXY kinematics. The tronxyX5S can be had for about 300 and you get 330x330x400 build area. im building a delta right now too based on an old Geeeeeeeeeeeeeeeeeeeeetech 301. again its only that in name now.....

Cheers
Ben
Reply


Messages In This Thread
new to me oneup - by floridaservices - 2019-03-23, 12:44 AM
RE: new to me oneup - by MisterAcoustic - 2019-03-23, 10:51 PM
RE: new to me oneup - by floridaservices - 2019-03-24, 08:33 PM
RE: new to me oneup - by MisterAcoustic - 2019-03-24, 11:28 PM
RE: new to me oneup - by floridaservices - 2019-03-25, 05:24 PM
RE: new to me oneup - by B3N - 2019-04-02, 03:12 AM
RE: new to me oneup - by mr_intensity - 2019-05-01, 09:34 AM
RE: new to me oneup - by mr_intensity - 2019-05-05, 05:00 PM
RE: new to me oneup - by floridaservices - 2019-05-06, 09:47 AM
RE: new to me oneup - by mr_intensity - 2019-05-06, 12:58 PM
RE: new to me oneup - by floridaservices - 2019-05-06, 03:12 PM
RE: new to me oneup - by mr_intensity - 2019-05-20, 12:13 PM
RE: new to me oneup - by mr_intensity - 2019-05-20, 12:42 PM
RE: new to me oneup - by floridaservices - 2019-05-24, 11:53 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)