Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New guy with ThreeUp startup issues
#11
Did you sort out your stick issue?
------
KS Printrbot Plus, modified
Thingybot Delta
QU-BD One Up (parts, received with bad motor)
QU-BD RPM (incomplete box-o-parts, spindle never received)
Maslow CNC (4'x8' chain drive)
Zenbot Mini (6"x8" router, grbl_ESP32)
SainSmart Genmitsu 3018Pro
Ender 3 Pro
BobsCNC Revolution (FluidNC)
Reply
#12
Yep. Now my issue is a configuration where I think I've got it to run the extruder at 240C for ABS, but it drops the setpoint down to 200C when I start printing.As you might imagine, the filament doesn't flow well when it's not melting.
Reply
#13
That sounds like a slicer configuration option. There's usually separate options for first (to improve sticking) and subsequent layer (better definition at lower temps, within reason) temperatures. You might need to turn on advanced options if your slicer has them
------
KS Printrbot Plus, modified
Thingybot Delta
QU-BD One Up (parts, received with bad motor)
QU-BD RPM (incomplete box-o-parts, spindle never received)
Maslow CNC (4'x8' chain drive)
Zenbot Mini (6"x8" router, grbl_ESP32)
SainSmart Genmitsu 3018Pro
Ender 3 Pro
BobsCNC Revolution (FluidNC)
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)