Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Snappy V2.0: Land of confusion.
#13
So, I wan't as close as I thought with the SIDEBRACE piece.  I used the Stream Editor (sed) to convert the points from my polygon command to PostScript.  Then, I laid a millimeter grid over it.  This way, I could lay the broken pieces (and in the end, the one good piece) on a printout of the grid/part, and make adjustments.

Oh man, I was off here and there on different parts of the shape..  You'll see on my final grid that the circular cutouts are not there (these are difference()d out after the polygon is drawn in OpenSCAD, so they are not part of the grid.  The circular cutouts are still just guesses, though.

The grid and a picture from OpenSCAD are attached.

The big, non-cirrcular curve is close.  I'll have to see if it works.

I ended up asking my buddy to 3D Print only these parts, and I will at least try to build the OneUp from them.

MisterAcoustic, Mooselake, thank you for your support.  I may post some of my progress on the filament printer forum.


Attached Files Thumbnail(s)
   

.pdf   SIDEBRACE_graphed.pdf (Size: 3.57 KB / Downloads: 0)
[Image: avatar_23.png?dateline=1515658171]
Reply


Messages In This Thread
Snappy V2.0: Land of confusion. - by mr_intensity - 2018-01-08, 02:00 AM
RE: Snappy V2.0: Land of confusion. - by mr_intensity - 2018-01-14, 12:26 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)