Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Looking for Setup Instructions - OneUp/TwoUp
#19
Hello everyone, it took me a while to come back after the QUBD burned down and me procrastinating the machine building.

I am posting all the files that I snagged at some point from their website. Many of them are DXF files (that can be opened in Illustrator or any other equivalent software) and have the laser pathways if you want to rebuild, print or probably 3D print the original parts.

The PDF is "Quintessential Universal Building Devices OneUp AND TwoUp PRINTER ASSEMBLY INSTRUCTIONS. Revision C - 8/29/2014" (Pending Upload)

QUBD Two-Up drawings and
Up_Firmware


Attached Files
.zip   QUBD Two-Up Drawings.zip (Size: 228.59 KB / Downloads: 7)
.zip   Up_Firmware.zip (Size: 194.97 KB / Downloads: 5)



_________________________________
QU-BD Up 2, Original Kickstarter with heated bed (heavy basalt stone), red PC Board
Prusa i3 V2
Snapmaker I, Original Kickstarter with 1600nm laser, Ziflex bed add-on
Snapmaker II A-350, Original Kickstarter (Pending)
Mayku Formbox, Original Kickstarter
Reply


Messages In This Thread
RE: Looking for Setup Instructions - OneUp/TwoUp - by EdOliver7 - 2020-04-01, 12:54 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)