2018-08-30, 11:59 PM
Hi xwarx7racer,
Sadly, I've never used an Octopi. A friend from work set one up for his Creality CR-10, but I don't know anything about it.
My main experience is with Repetier Host, and Cura. If one of those is running on the Octopi, I might be of more use, but I can't tell from your post.
In general, I don't think setting up your machine size in these softwares actually results in generated commands that don't exceed those bounds (though I may be wrong). I think the setup is more for visualization of model placement.
I have been a bit busy, but I will try to do a little research to see if I can put together enough knowledge to make some decent suggestions.
Stan
Sadly, I've never used an Octopi. A friend from work set one up for his Creality CR-10, but I don't know anything about it.
My main experience is with Repetier Host, and Cura. If one of those is running on the Octopi, I might be of more use, but I can't tell from your post.
In general, I don't think setting up your machine size in these softwares actually results in generated commands that don't exceed those bounds (though I may be wrong). I think the setup is more for visualization of model placement.
I have been a bit busy, but I will try to do a little research to see if I can put together enough knowledge to make some decent suggestions.
Stan